StimKit II "The Pulsar"
2-Channel Pulse Wave E-Stim Powerbox
Fully assembled and ready for use or in a self assembled DIY Kit
"The Pulsar" is a full featured Pulse Wave E-stim Powerbox that packs plenty of punch. Available fully assembled or in an easy to assemble DIY electronic kit. The kit version is supplied with all parts including the printed circuit board, pre-drilled enclosure, high quality front panel graphic overlay and easy to follow detailed assembly instructions. Power is provided by a commercial ac power adapter so you will never have to stop and change batteries right in the middle of a session. All that is required for assembly are a few basic hand tools and a fine point soldering iron.
FEATURES:
* Two independent electrically isolated channels A & B
* Independent controls for each channel provide full control of Output Frequency,
Pulse Width, Constant On or Intermittent Pulse Repetition, Lead Reverse
and Output Intensity
SIGNAL OUTPUT:
* Output Waveform: Variable Pulse Width Square Wave
* Output Frequency: ~10Hz - 1,500Hz
* Pulse Width: ~10uS - 150uS
* Int. Pulse repetition Rate: ~10 Seconds - 10 Hz
* Output Intensity: 0% to 100%
POWER ADAPTER:
* Meanwell GST18A12-P1J
* Universal Input 85-264 VAC
* Standard IEC320-C14 3-pole AC inlet
* 12VDC, 1.5 Amp Output
* Power Cord NOT included
POWER ADAPTER SAFETY COMPLIANCE:
UL62368-1, CSA C22.2 No.62368-1, TUV BS EN/EN62368-1
BSMI CNS 14336-1CCC GB4943.1, PSE J62368-1, AS/NZS 60950.1
BIS IS13252, KC K60950-1, EAC TP TC 004 approved;
SIRIM MS IEC62368-1 (optional) approved
Copyright 2023-2024 ©Stimkits
